Mercruiser Alpha One Sterndrive Parts
	Mercruiser Parts Mercruiser Help Mercruiser Manuals Mercruiser Tools Mercruiser Sterndrives Mercruiser Board Contact

Mercruiser Alpha One, R and MR Serial Numbers 6225577 THRU 0D469858

Insist on ONLY Original Factory Parts

Pre-Alpha Water Hose (5/8"ID) 32-32461 $12.00
Older transoms such as I and R drives used this smaller 5/8"ID water hose.
Always cut the hose to the length specified in the correct manual for your drive unit.

Alpha One and Alpha Gen II Water Hose

Alpha One and Alpha Gen II Water Hose (3/4") 32-41725-33 $14.00
Fits Alpha One and Alpha One Generation II gimbals with 3/4" ID hose.
Always cut the hose to the length specified in the correct manual for your drive unit.

Alpha One and Alpha Gen II Hose Clamps

Replace your hose clamps. Hose Clamp 54-815504412 $5.00 each.

Bravo Water Inlet Hose

The Bravo uses a pre-formed hose. 32-43437 Hose $35.00

The Bravo hose is held in place with plastic Tappered Inserts.
The Inserts thread into the ends of the hose to expand and lock them into place.
Installation requires the use of the special Tappered Insert Tool.
The forward end of the hose fits into the Gimbal Housing and is hidden behind the Hose Connector
inside the boat. When you remove the engine water inlet hose from the connector you can then
remove the connector from the inner gimbal to access the foward Tappered Insert.
You will need to replace the Connector Gasket during assembly.

Plastic Tappered Insert 41674 $2.00 each (requires two)

Tapperd Insert Tool 91-43579 $25.26

Connector Gasket 27-44108-1 $1.00 each

Part numbers and prices are subject to change.

©2004 Sterndrives.Com •Email • About Us • Home

• Mercruiser Help • Shop Manuals • Message Board • Contact

Note: We are NOT Mercury Marine or Mercruiser.